Maintenance Programs
Overview
Meter Engineers is pleased to announce our new preventative maintenance program. Under this program, Meter Engineers will send a technician to your site to service your equipment on a semi-annual, annual, or combination program. The semiannual procedure is basic preventative maintenance. The annual maintenance procedure is a complete inspection, cleaning, and thorough inspection of your equipment. The combination agreement includes both the semiannual and yearly trips and comes with a limited warranty
Auto-Sampler
Every 6 months
- Inspect operation of the flow switch(s)
- Inspect sampler pump(s)
- Inspect O-rings and gaskets inside sample block, replace as needed
- Inspect pressure gauges
- Inspect and set regulator(s)
- Inspect operation of all solenoids
- Inspect operation of check valves
- Clean 140 micron product inlet filter(s)
- Clean computer case and electronics
- Check operation of float switch
Every 12 months
Rebuild:
- Sample pump(s)
- 3-way solenoids if applicable
Replace:
- 140 micron product inlet filter(s)
- All check valve seats with rebuild kit
Fast Loop
Every 6 months
- Inspect operation of pump and magnetic coupling
- Inspect motor
- Test control system
- Clean out Y-strainer
Haze Tracker
Every 6 months
- Inspect and clean sight glass
- Torque bolts
- Tighten electrical connections
- Clean camera lens, adjust settings and alignment
- Clean computer, internal components, and electronics
- Inspect and clean light source
- Test function of float switch
- Test function of heater and thermostat
- Test self-cleaning system
- Check photo cell
- Run haze factor test
Replace:
- Replace lamp inside light source
- Every 12 months
- Everything listed under the 6-month plan
Rapid Flash
Every 6 months
- Replace air filters
- Replace Tygon tubing
- Replace used flash chamber sensors and flame arrestors
- Clean and inspect sight glass
- Clean and inspect 15 micron sample vapor filter
- Clean and inspect Product filter
- Clean and inspect optic level sensors
- Clean and inspect flow meter
- Inspect vacuum pump
- Inspect heater
- Inspect thermostat
- Test float switch
Manually Adjust:
- Airflow
- Sample fuel level
- Pressure regulator
- Inlet solenoid
- Vacuum control valve
- Pump control
Calibrate and Verify:
- Sensor bridge circuits
- Gravity input 4-20ma
- Temperature input (RTD)
- 4-20ma output
- Perform Vacuum test on system
Every 12 Months
Rebuild:
- All solenoids located inside cabinet (only RF2 and RF3)
Replace:
- 15 micron sample vapor filter
- 140 micron product filter
Recovery / Re-injection System
Every 6 months
- Inspect gearbox
- Inspect motor
- Inspect pump
- Inspect coupler
- Inspect operation of PLC
- Test float system (machine will need product for this)
- Clean out 230 micron product filter
Every 12 months
Replace:
- Lubricants in gearbox
- Lubricants in pump
- 230 micron product filter
Have Questions?
Product Support
From our floor to in-the-field, Meter Engineers products are manufactured and supported with rigorous detail. We proudly stand behind our products as a world-class support team; ready to assist customers when and how they need it. We are here for you.
Sales Inquiries
Do you need a metering solution for a specific application or flow rate on a job site? Or perhaps, you are looking for a custom prover product that delivers accuracy and dependability, but needs to adhere to some unique requirements? Contact our sales team, today!
Let's Stay In Touch
Meter Engineers continuously strives to develop the most innovative solutions for the Petroleum Industry and our customers. Sign up and be the first to know about products, services and support because exciting news is always worth sharing.
